Catalina - Capri - 25s International Assocaition Logo(2006)  
Assn Members Area · Join
Association Forum
Association Forum
Home | Profile | Register | Active Topics | Forum Users | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Catalina/Capri 25/250 Sailor's Forums
 Capri 25 Specific Forum
 keel to hull repair Capri 25
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

jsumrvl
Deckhand

Member Avatar

USA
9 Posts

Initially Posted - 06/30/2024 :  08:01:46  Show Profile  Reply with Quote
ran aground and now have a crack all around the keel.
how best to repair?
How to add a fillet at the keel hull joint.

Jim Summerville

joearcht
Navigator

Members Avatar

USA
239 Posts

Response Posted - 06/30/2024 :  09:15:47  Show Profile  Reply with Quote
Hi Jim,
I had the same problem on my boat but due to a different cause. A severe broach under spinnaker kept my boat from self righting so I had to climb out on the keel and counter weight the spinnaker to get her back on her feet. The results observed later was a cracked joint.
I used West System Six10 epoxy adhesive. I cleaned the joint down to fiberglass, re-bedded with the adhesive and tooled with a chalking tool. Let it cure and re-coated the hull with VC17.
That was in 2012 and the joint looks as good today as it did when I finished it. Now, I've not broached the boat that bad again but I have had it out in some good breezes.
Good Luck!

Joe W Hiller Jr
1985 Capri 25
Hull #433
Go to Top of Page

jsumrvl
Deckhand

Members Avatar

USA
9 Posts

Response Posted - 06/30/2024 :  19:03:28  Show Profile  Reply with Quote
Thanks Joe. That must of been a wild ride.
I am going to talk to the repair shop and see if it would strengthen the joint for the keel and hull by building up a fillet. Sort of like a cove mouilding. Some of the Capri boats have done this at the Wayazta Yacht Club, Minnesota.
My sail number is 443 1988 year.
I sail at the Lake of the Ozarks.

Jim Summerville
Go to Top of Page

Voyager
Master Marine Consultant

Members Avatar

USA
5307 Posts

Response Posted - 07/01/2024 :  15:54:52  Show Profile  Reply with Quote
I don’t have a Capri 25 however I’d be wondering if I grounded hard, then had a substantial crack around the keel, whether I had somehow broken something within the framework of the hull. Like the wooden underlayment of the fiberglass for example.
If the boat is hauled out and it is mounted on jackstands it would probably be a simple matter to measure whether the keel was loose. For example, raise up all 6 or 7 jackstands a few turns, and check to see whether the keel is still sitting on the ground, or if it raised up a little. Be careful doing this because the boat is supported by the keel normally when up on jackstands, and the whole setup could go unstable pretty quickly.
If the keel is still solid, then the repair process you outlined would probably work fine.

Bruce Ross
Passage ~ SR-FK ~ C25 #5032

Port Captain — Milford, CT
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Association Forum © since 1999 Catalina Capri 25s International Association Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.06
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.