Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.
All -- I'm searching for either a source for pre-cut back to the forward-facing seat in the dinette for my '80 SK/TR, or a template for cutting that back. Pointers, comments, are (as always) welcome, and my thanks to everyone in advance.
-Michael
Michael Wenger Norman OK (Lake Thunderbird) "Sea of Tea" (SK/TR)
Hi Michael, I have all the interior woodwork out of the boat at the moment to sand and varnish it. As I'm in Australia it's a bit difficult to send a template but if you don't have any luck in the US, I could measure the panel as accurately as I can and post the drawing. Would that work for you? Barry
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ. The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.