Assn Members Area · Join
Home. Association Forum Ships Store Cruising Racing Technical Tips Photo Gallery - New Boat Search - Updated Manuals & Brochures Swap Meet Links Officer Flag Line & Staff Bylaws & Constitution   Members Area Join the Association   Notice: The advice given on this site is based upon individual or quoted experience, yours may differ. The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.	Snickerdoodle - Mast Slot Plates These mast slot plates were made using 7/8 inch aluminum plastic tile trim. I used a pair of tin snips to cut them to length and then screwed them into the mast so that the little "L" fit into the opening. Three screws secure them in place. After all was tightened up, I used a small hammer to finish the outboard edge flush with the mast. It was a pretty easy job all told. These replaced some older, quite large plates that really didn't work very well at all.