Catalina - Capri - 25s International Assocaition Logo(2006)  
Assn Members Area · Join
Association Forum
Association Forum
Home | Profile | Register | Active Topics | Forum Users | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Catalina/Capri 25/250 Sailor's Forums
 Catalina 250 Specific Forum
 Replacing Pedestal Steering Rubber Boot in transom
 New Topic  Reply to Topic
 Printer Friendly
Author  Topic Next Topic  

rhs944
Deckhand

Member Avatar

USA
17 Posts

Initially Posted - 11/14/2024 :  10:40:05  Show Profile  Reply with Quote
I received the new rubber boot that covers the control arm to the rudder for the pedestal steering to replace the old torn one. As i have been unable to find an instructions or suggestions on what type of sealant/adhesive should be used, if any, in the replacement. At this point, if have not disassembled the existing mounting of the boot to the transom. But looking at it, it would appear that nothing was used as a sealer/adhesive for this type of installation. Reaction or suggestions on if some form of sealer/adhesive should be used? if so, what do you recommend

Rick 1999 C250 WK, Cape Cod

Voyager
Master Marine Consultant

Members Avatar

USA
5312 Posts

Response Posted - 11/16/2024 :  07:15:56  Show Profile  Reply with Quote
If you purchased it from Catalina Direct you can call them and ask for advice or resources. They have a very knowledgeable staff and probably can talk you through the installation. If not, then have you tried the Forum search tool?

Bruce Ross
Passage ~ SR-FK ~ C25 #5032

Port Captain — Milford, CT

Edited by - Voyager on 11/16/2024 07:17:04
Go to Top of Page

rhs944
Deckhand

Members Avatar

USA
17 Posts

Response Posted - 11/17/2024 :  08:56:24  Show Profile  Reply with Quote
I searched the forum as well as other sailing internet forums and didn't fined anything directly on point. All were more about the linkage installation and adjustment(s) and not about the installaiton of the rubber boot to the transom. Calling CD was farther down my list, as i was hoping somebody here had already been down this path before. Hoping to avoid wait times on tech calls.

Rick

Rick 1999 C250 WK, Cape Cod
Go to Top of Page

JB
Navigator

Members Avatar

USA
113 Posts

Response Posted - 11/17/2024 :  09:41:22  Show Profile  Reply with Quote
I did the same repair about two years ago. I used Boat Life Caulk (polysulfide based) because it's easy to remove and clean up. I figured I would be doing it again in a few years because that rubber isn't very UV tolerant. The rubber alone is probably good enough but I wanted the bolt holes to be sealed too.

1988 C25 Wing Keel Std Rig Tohatsu 9.9 Tiller Steering and 2003 C250 Wing Keel Std Rig Inboard Diesel Wheel Steering

Edited by - JB on 11/17/2024 09:42:29
Go to Top of Page

rhs944
Deckhand

Members Avatar

USA
17 Posts

Response Posted - 11/17/2024 :  10:40:08  Show Profile  Reply with Quote
That's my concern as well. Boot has been town for a while and no water appears to be entering the back cabin behind the battery box. Thanks for the tip!

Rick

Rick 1999 C250 WK, Cape Cod
Go to Top of Page
   Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Association Forum © since 1999 Catalina Capri 25s International Association Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.06
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.