Association Forum - Replacement boom gooseneck

Assn Members Area · Join

Home.

Association Forum

Ships Store

Cruising

Racing

Technical Tips

Photo Gallery - New

Boat Search - Updated

Manuals & Brochures

Swap Meet

Links

Officer Flag Line & Staff

Bylaws & Constitution

Members Area

Join the Association

Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.

Association Forum

Username:	Password:
Save Password
Forgot your Password?

All Forums

Catalina/Capri 25/250 Sailor's Forums

Capri 25 Specific Forum

Replacement boom gooseneck

New Topic

Topic Locked

Printer Friendly

Author

Topic

jmadd
1st Mate

Member Avatar

USA
85 Posts

Initially Posted - 11/01/2022 : 18:45:32

Another early Capri 25 problem. My gooseneck is shot. Catalina Direct has a replacement gooseneck but it only fits the later boats that have a single tab on the boom end extrusion. Mine has two tabs that fit over the mast pivot - that's the picture. Anyone dealt with this problem and come up with a solution? The rotation pin had nearly pulled out of the retainer.

LT_Smash
Deckhand

Members Avatar

Canada
15 Posts

Response Posted - 11/09/2022 : 14:50:35

Jmadd,

We had the same problem. Several weeks in a row we were hammering the two tabs back into shape on the way to the start line.

I ended up taking a piece of aluminium flat stock, about 1" wide and 6 inches long, and bending it into a U-shape that fit snugly around the vertical pin and the bit of the boom it fits into, then drilled holes so the horizontal pin held the aluminium band tightly in place. It's held together for over a year now with no issues.

if you want a sketch PM me your email and I'll send one, or a photo.

Edited by - LT_Smash on 11/10/2022 10:01:02

jmadd
1st Mate

Members Avatar

USA
85 Posts

Response Posted - 07/18/2023 : 19:18:51

Thanks for the offer Smash. I ended up being fortunate enough to get the original fitting built-up with aluminum weld then a friend machined it clean again. So far so good. Long story, but the welder lost the part for a while and before he found it we'd machined a part out of acetal plastic that would fit into the mast slide that is used on other Capris. I think that would have worked, and when we tweaked the design we were going to machine it out of aluminum. But just as I was fitting the acetal part the welder found the original gooseneck. This was part of a months long repaint the deck project. The boat just got back in the water a little over a month ago. Photos of that prototype.

jmadd
1st Mate

Members Avatar

USA
85 Posts

Response Posted - 07/18/2023 : 19:33:06

And I can't resist adding the pictures of the repaint.
Before (prep)

After

With more than a little help from my friends, especially Fred at America's Favorite Boat Shop http://schrothfiberglass.com/

GaryB
Master Marine Consultant

Members Avatar

USA
4299 Posts

Response Posted - 07/18/2023 : 19:41:48

Very nice job! Looks great!

Association Member

GaryB
Andiamo
'89 SR/WK #5862
Kemah,TX

Topic

New Topic

Topic Locked

Printer Friendly

Jump To:

Association Forum

Notice: The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.