Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.
We are replacing the head and discovered that the mounts are not the same dimension. How is access gained under the head to remove the old head? There is no access from either side of either bulkhead and even if I could get my hand through the waste hose hole with the hose removed there's no way to reach the nuts under the head. Looking at the picture I considered installing an inspection port like this one:
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ. The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.