Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.
Recently I pulled on my reef line and found myself staring at the bitter end. I've determined that to thread the line I have to remove the gooseneck. How to do without damaging aluminum extrusion? I tried using 16ga. wire to thread boom to no avail. Profanity followed shortly thereafter. After removing the two screws on either side of the gooseneck, I couldn't get it to budge. Your help is appreciated.
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ. The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.